MUSIC SHELF PLANS HOW TO

To have an easy time handling this step, you should have the right dimensions of wood. Step 10: Attach the Wood to Allow the Boxes to Lock Together Use as many screws as you would want but remember to drill the screws in a uniform pattern. You can force the wood pieces as you square the corners with the boards. You should only attach the panel supports if you have screwed the top and sides correctly. Step 9: Attach the Panel Supports on the Back This is quite helpful if you want to have a polished and attractive look. Drill the wood deeper to make sure that the screw head won’t stick out at all. Look for an extra-large drill bit after the pilot holes are well drilled. A drill same size as the screw will work better in this case.

Mark the spots with a sharp pencil for accuracy. With the top and bottom wood pieces above the sides, it’s time to estimate spots to screw in. Step 8: Put the Top and Bottom Wood Pieces above the Sides After sanding the wood, you can start the next step-putting the pieces of wood together. You might be satisfied with several layers of varnish. Keep in mind that the main goal here is to have the smoothest pieces of wood. Sanding the wood multiple times ensures that it is smooth. Check if the base is at an angle of 45 degrees from the floor. Kindly do it slowly instead of slapping a large bunch at a time.Īfter that, lay the wood on an angle preferably on a slanting wall. At this point, you should be extra careful about any loose brush hairs. Paint another coat after sanding the layer back and forth. Remove brush hairs that were left after painting the first layer. As you sand, you can take a look at what you did. It is time to sand the wood again after the coat is completely dry. It is proved that the tip increases the possibility that the wet wood parts will not stick to the newspaper. It would be better if you put the wood flat on a newspaper. You must be patient at this point otherwise you will not get the best results. The best way is to paint one side at a time and let it dry completely. The layer on the brush should not be very thick as this can cause excess drip on the sides of the wood. Step 4: Paint the First Layer of Varnishīefore painting the varnish, make sure that the tin is well stirred. Don’t forget to sand the wood with the grain. To have a smooth surface, consider using 320-grade sandpaper. Using the sanding block, sand the wood carefully until it is smooth. Alternatively, you can purchase already cut wood if you don’t have a table saw. Side panels on the other hand should measure 330 by 320mm. The top and bottom wood panels should be 400 by 300mm. Pick a big sized slab of ply since it is one of the most crucial ingredients in this project.

Remember that you are after woody texture at the end. It is worth noting that varnish does not work well with ply. However, ply thicker than 16mm can be used if it is sturdy enough.

It is advisable to avoid using ply because it warps easily and does not last for long. Vinyl Record Wall Storage RacksĪ post shared by Shawn Marquis the type of wood you want to use on your project. Homemade Vinyl Record Storage Ideas & Plans #1. Step 11: Carry Your Vinyl Record Storage.Step 10: Attach the Wood to Allow the Boxes to Lock Together.Step 9: Attach the Panel Supports on the Back.Step 8: Put the Top and Bottom Wood Pieces above the Sides.Step 4: Paint the First Layer of Varnish.

MUSIC SHELF PLANS HOW TO

How to Build a Modern DIY Vinyl Record Shelf Homemade Vinyl Record Storage Ideas & Plans.

Music shelf plans